High Pressure Water Blasting, also called HPS, is a well-known method for removing tough stains, grease, rust, etc from concrete surfaces. It is also known as “hot water blasting.” Hydro blasting is basically the same method, whereby, a high-pressure blast of hot water (450 bar or more) is utilized to remove Old Paint, Dirt, Rubber, Chemicals, or any other heavy buildup without causing any damage to the underlying surface.
The main benefit of utilizing a high-pressure water blasting system is that it causes the aggregate materials underneath the surface to break down into small beads. This provides themuch-neededd workable material for the new application. However, many believe that it is not completely necessary to employ this type of abrasive. While using this abrasive, it is quite important that the equipment is of the best quality and has the most powerful jets. Moreover, the blasting head and nozzle should have high-quality bearings.
One of the biggest challenges faced in using high-pressure water blasting systems is the use of abrasives. It is often difficult to control the size of the abrasive particles that are released during the blasting process. These particles often dislodge concrete surfaces and can create undesirable scratches on the surface. For this reason, the use of synthetic grit in the water jetting heads is very helpful.
In addition to abrasive grit, hydro-blasting systems also utilize high-pressure water jets for removing Old Paint, dirt, rust, etc. However, an important thing to note here is that it is important not to reuse the old grit that was originally used in the hydro-blasting operation. This would mean that you will be putting your grout and sealants at risk. Further, frequent usage of abrasive grit may eventually lead to a build-up of mineral deposits on the grout surfaces. These would eventually cause the deterioration of the grout.
The proper method of using water blasting is highly dependent on the type of contaminants present on the concrete or surface that needs to be cleaned. In case of a simple contamination, such as dirt or dust, simple water blasting using high pressure can take care of the problem. However, if heavy material contamination is present, then only the high-pressure jetting heads should be used. Also, it is important to note that once the dirt has been removed from the concrete surface, the soil should be swept away in order to prevent the buildup of contaminates in the future. If this cleaning process is not done correctly, there is a possibility that the same contaminants would accumulate in the system again.
High pressure water blasting is considered to be a very convenient and efficient method for cleaning concrete surfaces. It is also an eco-friendly technique as no chemicals are used in the process. But even with its many advantages, one must remember that it is very important to perform proper and adequate surface preparation before using the high-pressure jets. Failure to do so could result to costly damages that might even have to be flushed away.
It is therefore always advised to get in touch with a reliable and experienced company in order to find out more about the service they provide. Doing thorough research would help you learn more about the various techniques being used in the cleaning method. This will help you make an informed decision when selecting the best company in the business. Furthermore, doing so would also help you to learn about the advantages and disadvantages of using a particular high-pressure water-blasting service. Knowing all of this would definitely help you get the most out of the service that you are about to avail.
Another important thing to consider is the type of equipment used in the process. A lot of contractors choose to use high-pressure water blasting equipment even though it might prove to be a bit dangerous for the people who work in close proximity to these machines. You must therefore make sure that you find out more about the equipment your contractor uses prior to hiring them. This way, you will be able to ensure the safety of the workers in the job site. Thus, getting in touch with the right high-pressure water blasting company in your area would certainly make your construction site an ideal one to work on.